MONTHLY INSPECTION

General: Walk entire system and check for abnormal operation or vibration. Visually check for loose bolts or parts.
Safety: Walk entire system and check for possible safety hazards such as safety guards out of place and oil or grease spots on walkways. Check for snags, catch points and alignment of side guards and verify all safety devices are in place and functioning properly.
Motors, Clutches and Brakes:
Check that mounting bolts are secure, check for unusual voices, check couplers and remove dirt from breather vents.
Reducers:
Check oil level and visually determine that no oil is leaking from seals, temperature is ambient, moutning bolts are secure and remove dirt from breather vents. On shaft mounted reducers, see that torque arm jam nuts are locked.
Belting:
Check that belt does not slip at drive pulley, visually inspect that lacing is secure and undamaged, check belts for frayed edges, surface cuts, wear or damage and that there is no build-up of foreign substances or spillage of liquid. Check sheaves for proper alignment, inspect setscrews for security and excessive wear.
Pulleys and Rollers:
Check for build-up of foreign material, taperlock bushings and mounting bolts for security and inspect pulley lagging for signs of wear.
Bearings:
Inspect bearings for indication of failure, check that mounting bolts and setscrews are secure and lubricate bearings as needed.
Drive Chains:
Lubricate chain, inspect chain for proper tension, and check for wear.
Sprockets Inspect sprockets for alignment, adjusting and for wear and check set screws and keys for security.
Electrical:
Verify photoeyes and reflectors are securely mounted and aligned and indicator lights for proper functioning.

 

<<<NEXT PAGE>>>
<<<PREVIOUS PAGE>>>


Copyright © 2002-2004, Performance Installations. All Rights Reserved.